Connecting The Monitor - LG StudioWorks 775N User Manual

Connecting the Monitor

On the back of the monitor are two plug-in connections; one for the
AC power cord, and the other for the signal cable from the video card.
Power off both the monitor and PC.
Connect the 15 pin VGA connector of the supplied signal cable to the output VGA
video connector on the PC and the matching input connector on the rear of the
monitor. The connectors will mate only one way. If you cannot attach the cable
easily, turn the connector upside down and try again. When mated, tighten the
thumbscrews to secure the connection.
Locate the appropriate MAC to VGA adapter block at your local computer store.
This adapter changes the high density 3 row 15 pin VGA connector to the correct
15 pin 2 row connection to mate with your MAC. Attach the other end of the signal
cable to the side of the adapter block with 3 rows.
Connect the attached adapter block/signal cable to the video output on your MAC.
One end of the AC power cord is connected into the AC power connector on the
back of the monitor. The other end is plugged into a properly grounded three-
prong AC outlet.
Power ON the PC, then the monitor.
If you see the SELF DIAGNOSTICS message, check the signal cable and
connectors.
After using the system, power OFF the monitor, then the PC.
Power Cord
IBM PC
D-15P
Signal Cable
* NOTE : For Apple Macintosh use, a
separate plug adapter is needed to
change the 15 pin high density (3 row)
D-sub VGA connector on the supplied
cable to a 15 pin 2 row connector.
A5
MACINTOSH
Mac Adapter
D-15P