8-6. Cooling/Fan Only Operation
8-6-1. Operation Steps
Start
•
The OPERATION lamp (green) on the display
panel of the indoor unit starts flashing.
(1) Mode button
•
Select COOL, or FAN ONLY.
(2) TEMP. button
•
Push the TEMP. button.
•
Cooling 21°C or higher
(3) FA N button
•
Select any of the "AUTO", "LOW", "MED" and
"HIGH".
(4) START/STOP button
•
Push this button again to stop the air condi-
tioner.
•
The OPERATION lamp (green) on the display
panel of the indoor unit lights. Operation starts
after approximately 3 minutes. (If you select
FAN ONLY mode, the unit will start immedi-
ately.)
Stop: START/STOP button
•
Push this button again to stop the air conditioner.
Note:
•
The FAN ONLY mode does not control tempera-
ture. Therefore, perform only steps (1), (3) and
(4) to select this mode.
– 21 –
Fig. 8-10