Getting Started - Sony TRINITRON VAIO CPD-201VS Service Manual

Rear
!¡
!™
!£
!¢
!¡
AC IN connector
Connect the supplied power cord (page 13).
!™
2 Audio plug (green) Connect to the computer's audio output
(page 12).
!£
h MIC plug (red) Connect to the computer's microphone input
(page 12).
!¢
; Video signal cable Connect to the computer's video output
(blue) (page 12).
!∞
2 Headphones jack Connect standard mini-plug headphones (not
supplied). The speakers are turned off when
headphones are connected.
!§
Tilt-Swivel
Adjusts the angle of the display (page 15).
!¶
Subwoofer output
Connect to a subwoofer's input (not supplied).
jack
Functions of Controls
10
Installation
p Step 1: Connect the computer
With the computer switched off, connect the video signal cable to the
display (VGA) connector on your computer. If your computer supports
the DDC plug-and-play standard, this connection will enable DDC
communication between the display and the computer.
The video signal cable is combined with audio and microphone cables.
If your computer is equipped with sound capability, connect the audio
(green) and microphone (red) plugs to appropriate jacks located on your
computer.
2
PRINTER
AL MONITOR
Blue (to monitor LINE OUT
connector)
Green (to LINE OUT
connector)
Red (to microphone
connector)
Note on handling the video signal cable
Do not touch the pins of the video signal cable.
12

Getting Started

!∞
!§
!¶
USB
CONTR
LINE IN MIC
Fasten the
screw of the
blue plug.
Computer
Getting Started
Before using this display, please make sure that the following items are
included in your package:
• Multimedia computer display (1)
• Power cord (1)
• Warranty card (1)
• Operating instructions manual (1)
• Windows Monitor Information Disk and its instruction manual (1)
Tip
This display will sync with any IBM or compatible system equipped with VGA
graphics capability. Although this display will sync to other platforms running at horizontal
frequencies between 30 and 70 kHz, including Macintosh
cable adapter is required. Please consult Sony Technical Support for advice on which adapter is
suitable for your needs.
1) VGA is a trademark of IBM Corporation.
2) Macintosh is a trademark of Apple Computer Inc.
Step 2: Connect the power cord
p
With the display switched off, connect the power cord to the display
and the other end to a power outlet.
to a power outlet
Power cord (supplied)
Step 3: Turn on the display, and then your
p
computer.
For proper Plug and Play recognition, turn on the display before you
turn on your computer.
Note on Warning Messages
If there is something wrong with the input signal, one of the following messages appears.
"OUT OF SCAN RANGE"
This indicates that the input signal is not supported by the display's specifications.
"NO INPUT SIGNAL"
This indicates that video signal is missing.
To solve these problems, see "Troubleshooting" on page 36.
p Step 4: If necessary...
Adjust the user controls according to your personal preference.
The installation of your display is complete. Enjoy your display.
1-2
1) or greater
2)
and Power Macintosh systems, a
Continued to the next page
Getting Started 11
Getting Started 13