Assembling Steps For Alpha Jet - Art-Tech R/C Hobby Instruction Manual

WWW.ART-TECH.COM
Assembly steps for ALPHA JET
1．Take out the AB glue from the accessory bag, mix the glue in 1:1 ratio, and spread it on the surface between the
vertical wing and the tail of fuselage, and then paste them together.
2．Connect the servo plug in the aileron to the Y cable
in the receiver, put the ESC and other cables orderly in
the rabbet of the fuselage back, and then install the
main wing.
4. Make sure the switch on the transmitter is in the OFF
position. Place the 8 AA batteries in the back of the
transmitter. Ensure the throttle is fully closed before
turning the transmitter on.
www.motionrc.com
3． Fix the main wing into the fuselage with the 2 nylon
bolt from the accessory bag.
5. Connect the battery to the ESC, and install them in
the appointed position in the fuselage, and then cover
the seat.
6. Cover the cabin well and ensure every control
surface (Aileron and elevator) on the center position,
make sure the turning direction of each control
surface is consistent with the joystick direction. Or,
you can adjust the grip and the servo reverse switch
set in the transmitter to solve this problem.
8