Quick Installation - Venturer PLV21198 Instruction Manual

QUICK INSTALLATION

ATTACHING THE BASE STAND
• Before attaching (or detaching) the stand, unplug the AC cord from the AC input terminal.
WARNING: The LCD display is very fragile
and must be protected at all times when
attaching the base stand. Be sure that
nothing hard or sharp, or anything that could
scratch or damage the LCD display, comes
in contact with it. Do NOT place pressure on
the front of the unit at any time because the
screen could crack.
CAUTIONS:
• Attach the base stand in the correct
direction.
• Incorrect installation of the stand may
result in the unit falling over.
• Be sure to follow the instructions.
1. Confirm 4 screws (silver screws x2 & black
screws x2) are supplied with the unit.
2. Lay the unit down on a flat surface, so
the backside is facing up, making sure to
place a soft cushioned material (such as
a pillow or thick piece of foam) beneath
the screen.
3. Attach the BASE STAND to the opening
on the rear of the unit.
4. Insert and tighten the four screws
(supplied) into the holes as shown below.
Note: To detach the base stand, perform the
steps in reverse order.
MOUNTING ON THE WALL
This unit is VESA-compliant, and is designed to be wall-mounted with a VESA-compliant 3
15/16" x 3 15/16" (100mm x 100mm) mounting kit designed for flat-panel TVs (sold separately).
Mount this unit according to the directions included with the mounting kit.
Note: You must remove the base stand before mounting the unit on the wall.
3 15/16"
Four
mounting
holes
The Base Stand
Silver
screw
(x2)
Black
screw
(x1)
Soft cushion
E - 5
Black
screw
(x1)