Quick Installation; Turning On The Unit For The First Time - Venturer PLV76198 Owner's Manual

When you turn on your television set for the first time, be
sure to place it on a solid stable surface. To avoid danger,
do not expose the TV to water, or a heat source (e.g.
lamp, candle, radiator). Do not obstruct the ventilation
grid at the rear and be sure to leave sufficient gaps
around the unit as shown.

TURNING ON THE UNIT FOR THE FIRST TIME

The first time you turn on the unit, the unit will enter the setup mode. You can easily follow the prompt message on
the screen to complete basic TV settings.
Make sure the RF antenna has been
connected properly to the TV antenna
input jack on the rear of the system.
1. Press the / button to select Yes. Press the
ENTER button to proceed with the initial setup.
3. Use the / button to select Auto Scan, then press the
to select Start to Scan, press the
select Cable System before Start to Scan). The system will automatically start to scan and preset all available
TV channels.
4. After scanning has finished the system will return to the first TV channel scanned.

QUICK INSTALLATION

button to begin scanning. (If you selected CATV on Step 2, you need to
GB - 5
2
3/8"
2. Use the / button to select Antenna, then press
the / button to select Air or CATV.
button to enter auto scan menu. Use the
2
3/8"
2
3/8"
/ button