Connecting The Power Cord; Installation; Connections ........................................................................................... 8; Removing The Base Stand - Venturer PLV36190S5W Owner's Manual

CONNECTIONS
CONNECT THE POWER CORD
• Connect the AC power cord into a wall outlet.
• Press the STANDBY/ON button on the top of unit
or remote control to turn on the unit.
Note:
• Be sure the AC power cord is disconnected and
all functions are off before making connections.
• Make sure that all the components are connected
correctly.
• To prevent electrical shock, match wide blade
of plug to wide slot, and fully insert.
• When you are not going to use the unit for a long
period of time, disconnect the power cord.

INSTALLATION

REMOVING THE BASE STAND

WARNING: The LCD Display is very fragile, and must be protected at all times when removing
the base stand. Be sure that no hard or sharp, or anything that could scratch or damage the LCD
display, come in contact with it. Do NOT place pressure on the rear of the unit at any time
because the screen could crack.
1. Disconnect any cables or cords connected to the unit.
2. Lay the unit down on a flat surface, so the back side is facing up, making sure to place a
soft cushioned material (such as a pillow or thick piece of foam) beneath the screen.
3. Remove the four screws and then remove the BASE STAND from the TV.
PLV36190_ib_eng_1-14_wDVI.pmd
13
13
To AC outlet
18/01/2007, 17:01