Setting Up The Projector - InFocus LP330 User Manual

SETTING UP THE PROJECTOR

1 Place the projector on a flat surface.
The projector must be within 10 feet (3 m) of your power
•
source and within 6 feet (1.8 m) of your computer.
If you want to project from behind a translucent screen, set
•
up the projector behind your screen. See "Rear Projection"
on page 24 to reverse the image.
2 Position the projector the desired distance from the screen.
The distance from the lens of the projector to the screen and
•
the zoom setting determine the size of the projected image.
Figure 3 shows three projected image sizes. For more infor-
mation about image size, see "Projected Image Size" on
page 44.
3 Make sure the projector is unplugged and your computer is
turned off.
20 ft.
12 ft.
5 ft.
Projected image size at minimum zoom
F 3
IGURE
5