Table of Contents
Advertisement
Base Unit Description
Base Unit Face
POWER Light:
GREEN: charging; RED: battery power mode (unplugged from transformer); Blinking RED: low battery.
9 Vdc Transformer Plug:
Connect transformer here to charge the base unit battery.
Base Unit Bottom
5. Install Base Unit Battery
Remove the battery access cover using a small phillips head
Step 1:
screwdriver.
Plug the rechargeable Ni-MH battery into the receptacle
Step 2:
inside the battery compartment.
Replace the battery access cover.
Step 3:
Transformer
rev - 09-20-10
KEYPAD BATTERY INDICATOR Light:
LED turns ON when keypad battery is low.
PUSH TO ANSWER/TALK Button:
Use to answer CALL from keypad. PRESS and HOLD to talk; RELEASE to listen.
GRANT ACCESS Button:
Must be pressed before the person at the keypad can press any key to open the gate.
END CALL Button:
Allows user to terminate the call.
6. Connect the Transformer
110 Vac outlet
Step 1:
base unit. If you are mounting the base unit on the wall, use the template
(page 6) to place screws.
Step 2:
into the AC outlet and
connect it to the base unit's
power jack marked DC 9V.
VOLUME Control:
Controls volume level of speaker.
BATTERY ACCESS Cover:
Rechargable 3.6 Volt Ni-MH battery (included).
ON/OFF Switch:
Turn OFF to conserve power when battery operated.
ID SET button:
Used only to reassign new ID code (links base to keypad).
Battery Plug
Battery
Find a convenient location near an outlet to mount or place the
Plug the transformer
4
IMPORTANT: Allow the base
unit's battery to charge for 12
hours before using the system
for the first time.
Advertisement
Table of Contents
