Air Filter Installation (Optional) - Samsung IDH1800E Service Manual

7. Reassemble the centralized controller.
Caution :
•The optional kits must be installed by an installation
specialist.
•Before installing the optional kits, ensure that you have
turned off the main power.
•All optional kits cables should be installed according to
the national wiring rules and you must install them in the
wall not to be touched by users.
4-4-29. Wireless Remote Controller
Installation (Optional)
Accessories
Wireless Remote Battery(2)
Controller(1)
KR-H40100
Receiver & Cable-Tie(2)
Display Unit(1)
KRE-H2000
Wire Kit KWE-A110
Length : 10m
1. Remove the receiver & display unit cover by
using the tab on the bottom of it.
2. Open the receiver & display unit.
3. Connect the end of the connector wire to the
receiver & display unit and connect the other
end of the wire to the electrical component box
as shown in figure.
Caution :
•Do NOT keep the receiver & display unit cables with a
220V cable because the remote controller cables have
low voltage.
Samsung Electronics
M4 X 16 Tapped Remote Controller
Screw(2) Holder(1)
Cable Clamp(5) M4 X 16 Tapped
Screw(7)
4. Close the receiver & display unit.
5. Secure the receiver & display unit on the wall
with two screws.
6. Reassemble the receiver & display unit cover.
Caution :
•The optional kits must be installed by an installation specialist.
•Before installing the optional kits, ensure that you have turned
off the main power.
•All optional kits cables should be installed according to the
national wiring rules and you must install them in the wall not
to be touched by users.

4-4-30. Air Filter Installation (Optional)

The air filter can be installed to the bottom or rear of the
indoor unit depending the situation.
1. Remove two screws securing on the levers
under the bottom of the indoor unit.
2. Reassemble the levers making the other side
face the indoor unit as shown in figure.
3. Turn the levers not to prevent inserting the air
filter.
Installation
4-45