Seiko Cal. V17 Instructions Manual page 5

1. When the stopwatch is or has been measuring, if the crown is pulled out to the second click, it will
automatically reset the STOPWATCH hands to "0."
2. It is recommended that the hands be set to the time a few minutes ahead of the current time, taking
into consideration the time required to adjust the STOPWATCH hand position if necessary.
3. When setting the hour hand, be sure to check that AM/PM is correctly set. The watch designed so
that the date changes once in 24 hours.
4. When setting the minute hand, first advance it 4 to 5 minutes ahead of the desired time and then
turn it back to the exact minute.
2. STOPWATCH HAND POSITION ADJUSTMENT
I If the STOPWATCH hands are not in the "0" position, follow the procedure
below to set them to the "0" position.
STOPWATCH second hand
STOPWATCH minute hand
8
STOPWATCH 1/20-second hand
A
B
Press for 2 seconds to select the STOPWATCH hand to be adjusted.
A
l Selection of the hand can be made in the following order by
pressing button
STOPWATCH
1/20-second hand
* The selected hand turns a full circle.
Press repeatedly to set the selected STOPWATCH hand to the "0"
B
position.
* The hand moves quickly if button B is kept pressed.
* After all the adjustments are completed, check that the hour and minute hands for
time display indicate the current time.
Push back into normal position in accordance with a time signal.
CROWN
Screw all the way in until it is locked.
CROWN
A
for 2 seconds.
STOPWATCH
STOPWATCH
second hand
minute hand
9