Table of Contents
Advertisement
SETTING EXAMPLE:
0:00 ~ 7:00 SENSOR RECORDING
7:00 ~11:00 RECORDING DISABLED
11:00 ~18:00 RECORDING
18:00 ~24:00 SENSOR RECORDING
+ S S S S S S - - - - T T T T T T T S S S S S S +
:
:
:
0
6
11
Sensor recording installation
The unit provides 4 alarm inputs that can be configured as normally close
(+NC), normally open (+NO), on "SENSOR SETUP" menu option. (Please
refer to sensor setup section). After sensor configuration, please go back to "
RECORD SCHEDULE" menu to enable sensor recording.
Sub menu
SUB MENU
&PASSWORD CHANGE
TIME SET
DATE DISPLAY MODE YYYY/MM/DD
LINK TO PC
SEQUENTIAL TIME 1
PRESS (#$), THEN (
)
PRESS(! ) TO EXIT
NOTICE
The password can be only numerical (1-4) and up to 6 digit, use the following
buttons to input:
Means 1
Means 2
Means 3
Means 4
:
:
18
24
Enter into this option to change
password, time /date setting, date
format, enable the connection between
the unit and PC over USB interface
and setting CH sequential Time 1~9
sec. (in each or quad press enter
button to set sequential dwell time)
Password change
PASSWORD CHANGE
CURRENT PASSWORD: -------
NEW
PASSWORD:-------
PASSWORD CONFIRM:--------
PRESS (#$), THEN (
PRESS(! ) TO EXIT
The message will blink 5 times. Then the display goes back to SUB MENU.
If the password was not accepted, the unit will automatically return to SUB
MENU.
Time set
TIME
2004/03/21 03:23:21
PRESS (#$), THEN (
PRESS(! ) TO EXIT
Date display format
.
DATE DISPLAY FORMAT
PRESS (# # # # $ $ $ $ ), THEN (
PRESS(! ) TO EXIT
IMPORTANT NOTICE
Data and time are used to store and to search images in the HDD. Be sure to
set this information properly to avoid malfunction.
As periodical checking it is suggested to verify that date and time are properly
adjusted.
Enter into "PASSWORD CHANGE"
menu and the password change input
menu replaces the "SUB MENU" (The
default password is 111111).
When the new password is accepted,
)
the board will flash the following
screen message:
PASSWORD changed!!!
Enter into this option to adjust date
and time.
)
The unit can display the date in two
format yyyy/mm/dd or dd/mm/yyyy
variant which depends on the regional
)
preference.
Advertisement
Table of Contents
