Front Panel Buttons; Rear Panel - FARFISA INTERCOMS DVR42E User Manual

Front panel buttons

1. ! (Menu) button: press to display Operation menu option.
2. ! (Recording button): press to start recording.
3. " (Stop recording/playback button):press stop recording/playback
(the authorized password is requested upon stopping record;
the default password is 111111).
4. ! (Fast forward button): press to play the recorded stream faster.
5. ! (Playback button): press to start playback.
6. " (Pause button): press to pause the video playback.
7. # Reverse: press to playback backward.
8. Channel 1 button: press to select channel 1.
9. Channel 2 button: press to select channel 2.
10. Channel 3 button: press to select channel 3.
11. Channel 4 button: press to select channel 4.
12. All channels button: press to select all channels display.
13,14. $% up down buttons: press to change menu field.
15. (Select) button: Cyclic function. Press to change the setting value or enter
into a sub menu.
16. Power ON LED indicator.
17. Recording LED indicator.

Rear panel

1. S-Video output
2. Composite video output
3. Monitor: Secondary Video output
4. Video input
5. Video loop-through
6. Sensor input/alarm output: 4 sensor inputs and one alarm output
7. NTSC/PAL switch
8. DC-in (12Voltage)
9. Power switch
10. USB 2.0 link to PC
Notices:
- Before powering the system, check that the video system selector is properly
switched to the standard (NTSC/PAL) used.
- To avoid noise and bad images it is very important to run 75Ω coaxial cable
between cameras, DVR and monitor. Choose the correct kind of cable
according to distance and avoid to run video signal cables together with mains
cables.
- Use only 75 Ω BNC connectors for each cable to respective video input and
pay attention during their installation. Many times not proper functioning,
noises and low quality images are due to bad connections.
- Always switch off the DVR before change any connection.
-
To avoid HDD from loose data, stop recording before switch off the
.
DVR