Table of Contents
Advertisement
Power up the unit
After the unit is properly installed, the DVR is ready to record and play. Then
apply power supply provided and switch on.
After the unit is powered on, the
unit will check the HDD for
several
seconds.
The
information shown will be as:
The unit will enter into real-time
display mode shown in the
figure.
Notice:
To
resume
factory
default
settings, push 5 time # button
and the message "Turn off and
on the DVR" will be displayed.
Then to complete the reset
operation, turn off and on the
DVR.
The above procedure will not
delete the images recorded in
the HDD.
HDD CHECKING
OK
CH1 CH3
CH3 CH4
Turn off and on the DVR!
The On Screen Display
1. Power on the system
CH1
CH3
Press " button to
stop playback
CH1
CH3
Playback mode
Press ! button
CAMERA SELECT
to display OSD menu
RECORD SELECT
RECORD MODE
RECORD FRAMERATE 25
Press ! button to exit
VIDEO QUALITY
OSD menu to real-time
RECORD SCHEDULE
display
SUB MENU
HARD DRIVE SETUP
SENSOR SETUP
OSD Mode Display
Press % button to
start recording
Press " button to stop
recording (password is
requested!)
Recording Mode Display
Press ! button to
search time or event to
04/03/24 13:24:21-04/03/24
playback
13:44:54
>01 TIME 04/03/24 13:24:21
>02 TIME 04/03/24 13:30:55
>03 TIME 04/03/24 13:40:54
Press ! button to exit
(#$) MOVE,(" )
the menu
CHANGE,(!)PLAY
Press ! button to
start playing
MAIN MENU
1234
1234
EACH
HIGH
CH1 ● ● ● ●
● ● ● ●
SEARCH TIME
HDD: MASTER
Search Mode
Advertisement
Table of Contents
