Install Paper; Setup Procedure - Panasonic DP-130 Operating Instructions Manual

Install paper

Push the paper tray into copier. Plug in the unit and turn on the power. When
the Add Paper Indicator (J J J J J ) lights, install paper using the following procedure.
1
2
3
4
5
When making 2-sided copies, use the sheet bypass.
C
ATTENTION
If the paper tray is not closed completely, the Add Paper Indicator in the
C
control panel will light up. In that case, please close the paper tray
completely.
For changing paper size, see page 19.
C
Set-up is completed. Now ready to make a copy.

Setup Procedure

Lift slightly and pull paper tray out
of copier until it stops.
Push the bottom plate down until it
locks.
Install the paper guide into the
holes that correspond to the paper
size you plan to load.
Place paper.
Up to 250 sheets.
Do not fill above.
# Slide the paper guide (front) to
the paper edge.
$ Push the paper tray back into
copier.
Overfill Indicator
1-sided copy
13