Frigidaire HC88 Series Installation Instructions Manual page 6

INSTALL HOOD (Continued)
For Ducted Installations Only:
FIG. 10
BLOWER DISCHARGE
HORIZONTAL DUCTING
7. Reinstall blower. Do not grasp blower by blower wheels.
Position blower so that blower discharge lines up with
damper/duct connector and slip rods into mounting brack-
ets on blower assembly. (FIG. 10) Tighten knurled nuts
securely, and plug in blower.
For Ductfree Installations Only:
FIG. 11
BLOWER
DISCHARGE
7. Reinstall blower. Do not grasp blower by blower wheels.
Move blower mounting rods to front holes in hood support
channels. (FIG. 11) Position blower so that blower
discharge lines up with louvered opening on hood front.
Slip rods into mounting brackets and tighten knurled nuts
securely. Plug in blower.
Remove louver cover on control panel. Pry cover off with
screwdriver or knife.
8. Reinstall bottom cover and screws. See FIG. 2.
For Ducted Installations Only:
FIG. 12
9. Reinstall aluminum filters. Make sure tabs are toward
outside and bottom. (FIG. 12)
VERTICAL DUCTING
LOUVER COVER
3
2
1
INSTALL HOOD (Continued)
For Ductfree Installations Only:
9. Snap aluminum filter onto front of replacement filter. (FIG.
13) Make sure that tab on aluminum filter lines up with
finger pull on replacement filter.
FIG. 13
Push filter assembly into hood. Flaps on filter will flex
against top and sides of opening. (FIG. 14) Push
assembly up until bottom of assembly clears lip on bottom
cover. Insert bottom of filter and pull assembly down,
collapsing pull ring against aluminum filters.
FIG. 14
10. Turn on power and check operation of hood.
6
3
2
1