Keystone KSTAT12-1A User Manual page 17

Wall Sleeve Brands:
7
60
Top View
Rear Louvers
60
#2 Fedders
1. Redirect the louvers at the back of the wall
sleeve as shown in the illustration. The use
of pliers is recommended.
1 /
1
2. Attach(1)4 x3 x1
2
one on each side wall. Place in center of side
wall with the tapered end facing the opening.
3. Cut (2) 17 Tapered Spacer Blocks as shown
below into two pieces.
3
/ Tapered Spacer Block
4
Cut Here
4. The 4 section is placed in front of the rib on
base with the tapered end facing the back of
the sleeve. The remaining portion will be
placed behind the rib again sloping toward
the rear of the sleeve. This helps induce a
rearward slope on the unit.
5. Attach (1)4 1 x3/8 x25 long seal in the center
/
2
at the top of the sleeve. Remove the backing
paper and press into position.
1
/
6. Attach (2) 1 x3/8 x14 seals to the left and
2
right sides of the sleeve.
7. Cut the 1 1 x3/8 x25 long seal to 14 long
/
2
and attach it to the vertical section of the rear
grille as shown.
8. Gently slide unit into sleeve.
9. Before sliding all-the-way back, remove 2nd
screw from front on left side of unit.
10. Remove the plastic washer from the screw.
11. Screw and attach the other end of the ground
wire to the unit as shown in picture. Make sure
that the toothed washer is against the cabinet.
12.Slide the unit completely to the rear to ensure
a good seal, making sure the ground wire does
not become tangled.
13.Seal & Frame the unit as described on the last
page of these instructions.
13
3 4 /
19 Deep
/ /
1 / / centering/support blocks
2 2
2 2
17
1
Protection Paper
Backing