Installation; Connecting The Monitor - LG Flatron 775FT User Manual

Connection to any IBM
VGA PC compatible
system

Connecting the Monitor

Figure 1 shows the signal cable connections from the monitor to the
Video Graphics Array (VGA) port typical in an IBM PC or PC
compatible. This also applies to any graphics video card for PC-CAD
or workstation that has a 15 pin high density (3 row) d-Sub connector.
1.
Power off both the monitor and PC.
2.
Connect the 15 pin VGA connector of the supplied signal cable to the
output VGA video connector on the PC and the matching input
connector on the rear of the monitor. The connectors will mate only
one way. If you cannot attach the cable easily, turn the connector
upside down and try again. When mated, tighten the thumbscrews to
secure the connection.
3.
Power ON the PC, then the monitor.
4.
If you see the SELF DIAGNOSTICS message, check the signal cable
and connectors.
5.
After using the system, power OFF the monitor, then the PC.
Power Cord
A4
Signal Cable
Figure 1.

Installation

D-15P