System Environment - LG GCE-8523B Owner's Manual

DirectCD v2.5b(s)
TM
Computer
Software
Introduction

System Environment

This unit can be operated in the system environment explained here.
CPU
System
requirements
Memory
Hard disk
Interface
Drive bay
Power
Software Required OS
CD-R, CD-RW discs
❏ Occasionally the CD-R and CD-RW discs written by the CD-R/RW
drive cannot be read by other CD drives*.
These unreadable discs may need to be read using the CD-R/RW
drive on that did the original writing.
* The disc written using the CD-R/RW drive might not be readable by CD-ROM
drives other than Multi-read compatible (UDF compatible) CD-ROM drives.
Multiread compatible (UDF compatible) CD-ROM drives are:
1. CD-ROM drives that can read low reflectance.
2. CD-ROM drives that support Packet Write.
Install the supplied CD Recording Software before using this unit.
4
350MHz (or faster) Pentium (for high speed,
500MHz or faster recommended)
Windows 95/98/ME : 64MB or greater.
Windows NT Workstation Ver. 4.0: 64MB or
greater (128MB or over recommended)
Windows 2000/XP: 128MB or greater(256MB or
over recommended)
700MB or more free space.
(The free space needed for writing depends on
the quantity of data.)
Enhanced-IDE interface (as Primary Slave,
Secondary Master or Slave)
5.25-inch half-height bay required
+5V/+12V power socket required
Windows 95/98/2000/ME/XP, Windows NT
Workstation Ver.4.0 or later
CD-R : LG, Ricoh, Mitsubishi Chemical, Taiyo
Yuden, Fuji Film, CMC, Mitsui or SKC discs are
recommended. (For 52X-700MB: CMC, SKC,
Ritek, Fuji Film, Ricoh, Daxon, Maxell, Plasmon, MBI)
CD-RW : Ricoh, Mitsubishi chemical, TDK, Fuji
Film, Sony discs are recommended.