Advertisement
JVC HR-DVS3U
Quick Reference
USING THE INPUT JACKS ON THE FRONT OF THE DECK (F-1):
1. Using the channel wheel, as mentioned in the above note, channel
down below CH 2 until the readout on the front window displays F-1.
2. The default input of this VCR is "VIDEO." In this mode, the yellow
input jack on the front is expecting a signal.
3. If you are connecting a composite source, skip to step 4. If you are
connecting an S-VHS source, use your remote to do the following:
a. Press MENU.
b. Using the up or down arrow, move the highlight bar to
"VHS MODE SET" and select it with the OK button.
c. Move the highlight bar to "FRONT AUX INPUT" and then
press OK to set "S-VIDEO."
d. Press MENU when done to exit out of the menu.
4. Open your editing program.
5. The signal from your other studio equipment which is feeding the
front input jack on the front of the deck should now appear in your
capture window as well as on the monitor on the deck.
NOTE: If you can see the input on your monitor, but not in your cap-
ture, try restarting the editing program or unplugging your fi rewire and
plugging it back in.
Guide
Using the Deck as a Media Converter
This section explains how to connect other studio equipment
to the deck and feed the signal to and from that equipment into
or out of a computer connected to the deck.
Remove all mini-DV cassettes before proceeding.
NOTE: To change the channel, turn the jog/shuttle wheel.
However, if a tape is in the deck, stop the tape, press the
jog/shuttle wheel once, and now you can change the chan-
nel. Turning the wheel left will channel down and turning the
wheel right will channel up.
3
Advertisement
