Preparation Before Operation; Remote Controller; Auto Restart Function - Mitsubishi Electric MSZ-FA25VA Operating Instructions Manual

NAME OF EACH PART

Remote controller

Signal transmitting section
Operation display section
ON/OFF (operate/
stop) button
Open the front lid.
Fan speed control button
Operation select button
ECONO COOL button
PLASMA button
AREA button
i-see button
RESET button

PREPARATION BEFORE OPERATION

■
Auto restart function is ...
When the indoor unit is controlled with the remote controller, the operation mode, the set temperature and the fan speed are
stored in the memory. If a power failure occurs or the main power is turned off during operation, "Auto restart function" sets
automatically to start operating in the same mode as the one set with the remote controller just before the shutoff of the main
power. (Refer to page 6 for details.)
■
Temperature buttons
Remove dirt from the power supply plug and insert the plug securely.
If dirt adheres to the plug or insertion is incomplete, it may cause a fire or an electric shock.
■
■
WIDE VANE button
(Vertical vane button)
Where is the indoor unit installed in your room?
Off-timer button
On-timer button
TIME set buttons
Forward button
Backward button
CLOCK set button
Vane control button
(Horizontal vane button)

Auto restart function

These models are equipped with an auto restart function. If you do not want to use this function,
please consult the service representative because the setting of the unit needs to be changed.
Outdoor unit
Insert the power supply plug into the power outlet and/or turn the breaker on.
WARNING:
Remoto controller
Use the remote controller provided with the unit only. Do not use other remote controller.
Be sure to set the slide switch inside the remote controller to an appropriate position in accordance
with the installed position of the indoor unit. If the switch is not set correctly, the air conditioner
may not function properly.
Side swich
Installed at left, if the Installed at right, if the
distance is not more distance is not more
than 50 cm. than 50 cm.
(Left) (Center) (Right)
* If the indoor unit is installed more than 50 cm away from the side walls, cabinets or other nearby objects, set the slide
switch to the "center" position.
Area Left Center
Position of
the slide
switch
Display on
the remote
controller
Is the indoor unit in-
stalled at right, left or
center?
Right
4