Response Center. DO NOT RETURN THIS PRODUCT TO THE STORE. Fill in and retain The HOOVER vacuum cleaner you have just purchased is a It can be used with or without tools for quick clean-up on ail types of surfaces.
Do not use charger with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer.
Unpacking Unpack the cleaner from carton. Remove and dispose of cardboard packing. A standard and a deluxe cleaner is available. Identify the model you have purchased and the parts included. A. Hand-held cleaner B. Wall bracket C. Charger and cord D.
Questions or The Hoover Company wants to quickly resolve any concerns about your cleaner or questions regarding its use. Look on the list provided with the product for your local Hoover Factory Service Center or in the Yellow Pages under “Vacuum Cleaners - Household”...
If wall bracket is.belng mounted onto dry wall, plaster, or thin paneling backed by dry wall or plaster*, enlarge starter holes to diameter. Push plastic anchors fully into holes. Place bracket on wall over anchors. Begin driving screws into anchors. Tighten screws securely. ‘Do not attempt to mount wall bracket onto thin paneling without a dry wall or plaster backing.
Remove the cleaner from wall bracket and depress ON/OFF switch to operate. Release switch to turn cleaner off and to conserve power between tasks. Cleaning tools (available with some models) The cleaning tools added to the multi-purpose nozzle make it easy to complete the following tasks: may be used for wet or dry pick-up in tight...
Picking up liquids and wet debris Use this cleaner to pick up liquids and wet debris or a combination of each. Hold the nozzle end down after wet pick-up to avoid any spillage. The collector cup will hold approximately 8 oz. of liquid. To check the liquid level, hold cleaner with nozzle down;...
Page 9
ON UPHOLSTERY 1. Immediately vacuum up as much of the spill as possible. 2. Follow the furniture manufacturer’s instructions for spot cleaning the upholstery, using your cleaner whenever possible. NOTE: Do not attempt to pick up a solvent based product with this cleaner.
Page 10
4. Reassemble cleaner by hooking projection on bottom of motor/ handle section into opening in bottom of cup. Pivot sections together, making sure latch is secure. Continue using your cleaner. If a drop in performance is noted, refer to problem chart in the back of this book.
6. If necessary, wash and dry cup before assembly. 7. Align filter frame with separator frame and press edges together. 8. Replace filter / separator assembly into collector cup. 9. If soiled, wipe motor/handle section with a damp cloth. Do not immerse in water.
(U.S. only). Do not send your cleaner to The Hoover Company in North Canton for service, this will only result in delay. Response Center, North Canton, Ohio 44720 Phone: 216-499-9499.
Need help?
Do you have a question about the Dubl Duty and is the answer not in the manual?
Questions and answers