Connecting To The Mains Water Supply; Drainage Connection - CDA ci860 Manual For Installation, Use And Maintenance

Connecting to the Mains Water Supply

• Fit the seal included in the hose packing at the end of the water
inlet hose on the tap side.
• Connect the water inlet hose to a ¾" BSP water tap. Then securely
tighten the connecting nut by hand.
• After connections are completed, check there are no leaks from the
connection joints by turning on your tap completely.
For your washer dryer to work properly, the mains water pressure
must be between 0.05 and 1MPa (0.1 - 10 bar).

Drainage Connection

• It is recommended that you have a
fixed drainage outlet 50 to 80 cm
from the floor.
• Avoid the drain hose being too tight,
kinked or restricted.
• The water outlet can either be
connected to a water drain or to a
sink outlet spigot. This connection
should be a minimum of 50cm and
a maximum of 80cm from the floor.
The drain hose should be no longer
than 4m in length to ensure good
performance from the washer dryer.
• After connecting the water supply,
check to ensure there are no leaks.
34
max
80 cm
min
50 cm
fig. 8