Setting Up The Plot (Plot Setup View); Trouble-Shooting A Plot - HP 39g+ User Manual

H I N T

Setting up the plot (Plot setup view)

Plot type (1VAR)
Histogram width
Histogram range
Plotting mark
(2VAR)
Connected points
(2VAR)

Trouble-shooting a plot

8-18
In order to access the CORR and RELERR variables after
you plot a set of statistics, you must press
the numeric view and then
correlation values. The values are stored in the variables
when you access the Symbolic view.
The Plot Setup view (
same plotting parameters as it does for the other built-in
aplets.
See "Setting up the plot (Plot view setup)" on page 2-5.
Settings unique to the Statistics aplet are as follows:
STATPLOT enables you to specify either a histogram or
a box-and-whisker plot for one-variable statistics (when
is set). Press
setting
HWIDTH enables you to specify the width of a histogram
bar. This determines how many bars will fit in the display,
as well as how the data is distributed (how many values
each bar represents).
HRNG enables you to specify the range of values for a set
of histogram bars. The range runs from the left edge of the
leftmost bar to the right edge of the rightmost bar. You
can limit the range to exclude any values you suspect are
outliers.
S1MARK through S5MARK enables you to specify one of
five symbols to use to plot each data set. Press
change the highlighted setting.
CONNECT (on the second page), when checkmarked,
connects the data points as they are plotted. The resulting
line is not the regression curve. The order of plotting is
according to the ascending order of independent values.
For instance, the data set (1,1), (3,9), (4,16), (2,4) would
be plotted and traced in the order (1,1), (2,4), (3,9),
(4,16).
If you have problems plotting, check that you have the
following:
to display the
-
) sets most of the
SETUP PLOT
to change the highlighted
to access
to
Statistics aplet