Suspended Ceiling T-Bar Installations - Extreme Networks Altitude 3510 Installation Manual

Hardware Installation

Suspended Ceiling T-Bar Installations

A suspended ceiling mount requires holding the AP3510 up against the T-bar of a
suspended ceiling grid and twisting the AP3510 chassis onto the T-bar.
The mounting hardware and tools (customer provided) required to install the AP3510
on a ceiling T-bar consists of:
Safety wire (recommended)
●
Security cable (optional)
●
To install the AP3510 on a ceiling T-bar:
1 If required, loop a safety wire — with a diameter of at least 1.01 mm (.04 in.), but no
more than 0.158 mm (.0625 in.) — through the tie post (above the AP3510's console
connector) and secure the loop.
2 If required, install and attach a security cable to the AP3510 lock port.
3 Attach the Radio 1 and Radio 2 antennas to their correct connectors.
For information on the antennas available to the AP3510, see
Options" on page 12.
4 Cable the AP3510 using an approved line cord and power supply.
For standard power adapter and line cord installations:
a Connect a RJ-45 Ethernet cable between the network data supply (host) and the
AP3510 LAN port.
b Verify the power adapter is correctly rated according the country of operation.
c Connect the power supply line cord to the power adapter.
d Attach the power adapter cable into the power connector on the AP3510.
e Attach the power supply line cord to a power supply.
CAUTION
Do not actually connect to the power source until the cabling portion of the installation is
complete.
NOTE
For other options to power up the AP3510, refer to
18
"AP3510 Antenna
"Powering the Access Point" on page 13.
Altitude 3510 Access Point Installation Guide