Operation - DeWalt D364-O4 Instruction Manual

HEX NUT
ADJUSTING THE SHOE PRALLEL TO THE BLADE
1.
DISCONNECT PLUG FROM POWER SUPPLY.
2.
Loosen
the hex nut
shown
in (Figure 12) and then turn the
adjustment screw
in
or out as needed to adjust for parallelism.
3. Adjust the shoe until
it is
parallel to
the
blade by measuring
from the edge of the shoe to the
blade,
front
&
rear.
You
can
measure from
the
outside edge
of the
blade
to the shoe
as
shown in (Figure
12)
or from
the
inner edge of
the
blade
to
the
wider part of the shoe. (Do not
measure from the
tips of
any
saw blade teeth.)
4.
When
the shoe and blade are parallel, hold the
adjusting
screw in place and tighten the hex
nut
firmly.
Operation
SWITCH
Pull
the trigger switch to turn the motor "ON".
Releasing
the
trig-
ger turns the motor.OFF". Releasing the trigger
also automatical-
ly
actuates the electric brake. This
tool has no provision
to
lock
the switch in the
"ON" position, and should never
be locked "ON"
by any other means.
WORKPIECE SUPPORT
Figure 13 shows proper
sawing position.
Note
that hands
are
kept away from cutting area, and power cord is positioned
clear
of the cutting area so that it
will
not
get
caught
or
hung up on the
work.
To avoid kickback, DO support
board
of panel
NEAR the cut
and
on
both sides
of the cut, (Figure 14).
DON'T support board or
panel away from the cut, (Figure
15). When ripping long narrow
strips, support cut-otf waste material.
When operating
the saw,
keep the cord away from the cutting
area and prevent it from
becoming hung
up on the
workpiece.
Note
that a special Cord
Keeper
has been provided on the tool's
handle,
as shown in Figure 4. Simply press the cord into
the
keeper to keep it
in sight and out of
the way.
QUADRANT
HEX
POINTER
NUT
SCREW
FtG.
12
FtG.
13