Adjustments And Setup - DeWalt D364-O4 Instruction Manual

Adjustments and Setup
ATTACHING AND
REMOVING
BLADES
DISCONNECT PLUG FROM POWER SUPPLY.
To
attach the blade, retract lower blade guard and place
inner
clamp washer and blade on saw spindle with printed side
of
blade
out (teeth at
bottom
ol
blade pointing forward) (Figure 1).
lnstall
outer clamp washer. The
larger sufaces
of
both washers must
face
the
blade. Thread
on blade clamping screw firmly by hand to
hold washers in position.
Lightly depress the
blade
lock (Figure 2) while
turning the
spindle
until
the
blade stops rotating. Tighten blade clamping
screw
(clockwise)
firmly with the
blade
wrench (Figure
3).
NEVER ENGAGE
BLADE LOCK WHILE SAW
IS
RUNNING,
OR
ENGAGE
IN
AN
EFFORT TO
STOP
THE TOOL.
NEVER TURN
SWITCH ON
WHEN
BLADE LOCK IS ENGAGED.
When
removing the
blade,
first
unplug
the saw.
Engage the blade
lock and
unscrew
the
blade clamping screw
by
turning
it counter-
clockwise with
the
blade wrench.
CUTTING DEPTH ADJUSTMENT
DISCONNECT PLUG FROM POWER SUPPLY.
Loosen (counterclockwise)
the Cutting Depth Adjustment
Knob,
shown
in
(Figure
4).
Lift the saw handle, as shown in the
figure,
to
adjust it to the desired height. Tighten the
knob to secure
it
in
place. lf
depth of cut cannot be adjusted, inspect parts for
dam-
age and service as required before use. A
scale and
pointer
is
provided
to
enable
you to
select
a
specific depth of cut.
Simply
align
the pointer, shown in (Figure 5), to the desired depth of
cut.
FIG.1
INNER
CLAMP
WASHER
OUTER
CLAMP
WASHER
BLADE
CLAMPING SCREW
LOOSEN
Y.'
BRUSH INSPECTION CAP