HP 200 Series Services And Applications page 231

ISDN Wide Area Network Design: Dry Creek Joint Elem. School District
District Office Router
Basic configuration: Host-only bridging enabled, TFTP enabled,
SNMP enabled, and Telnet enabled. The district office router is the
originator and causes the terminal adapter to make the call when the
router is booted and its DTR goes high.
HP Router SR ISDN Circuit Configuration:
Circuit Name: WAN2
Auto Enable: YES
Quality of Service:
Circuit Type: ISDN Manual Adapter
Min Frame Spacing:
Connect Retry Count:
Connect Wait Time (sec):
Delay After Connect Failure (min.):
District Office Terminal Adapter (TA)
AT&T 7500B Data Module operating in synchronous DCE mode acting as the
originator.
Configuration:
Set Autodial = YES
Set busy out = OFF
Data Rest = OFF
Set DTR = FOLLOW
Set Duplex = FULL
Set mode = CS
Set speed = 64000
The ISDN telephone number for the remote site is configured in the terminal
adapter's call table; the autodial feature engages when the router's DTR goes
high.
LLC1 (datagram)
2
3
15
.5
ISDN Configurations
3-37