Cleaning The Appliance; Odours; Warning Messages Via The Display - Siemens FI18NP Series Operating Instructions Manual

Cleaning the
appliance
Press the on/off button
and switch the appliance off!
Pull out the mains plug or switch off
the fuse.
Clean the appliance with lukewarm
water and a little washing-up liquid.
Water used for cleaning must not
drip onto the fascia or light.
Clean the door seal with water only
and then dry thoroughly.
Remove dirt on the ventilation
and air release openings using
a vacuum cleaner.
Clean the surface of the appliance
using a damp cloth.
Afterwards, rub dry.
After cleaning:
Insert the plug and/or switch the fuse
on. Press the on/off button
switch the appliance on!
m
Warning
– NEVER use a steam cleaner
to clean the appliance!
– Water used for cleaning must
not drip onto the fascia or light.
– Do not use abrasive or acidic
cleaning agents and solvents.
– Never clean the shelves or
containers in the dishwasher.
The parts may warp.
16

Odours

If you experience unpleasant odours:
Press the on/off button
and switch the appliance off!
Take all food out of the appliance.
Clean the interior. See section
"Cleaning the appliance", page 16.
Clean all packing units located in
the appliance.
Seal strong smelling food in order
to avoid odours from forming.
Press the on/off button
and switch the appliance on!
Store food in the appliance.
Check whether the formation
of odours is still occuring after
24 hous.
Change the odour filter.
and
Warning messages
via the display
If several warning notices appear at
once, see to each warning in turn.
As long as a warning is displayed,
no buttons can be
Door alarm
Cause
One door of the appliance has not been
closed correctly or has been open too
long.
Remedial action
Press the alarm button
Close the door.
The display goes out.
pressed.6.
.
Sensor failure
Cause
A technical defect on the appliance
is possible.
Remedial action
Conduct a self-test on the appliance.
Low voltage
Cause
The mains voltage falls below
the permitted limiting value.
Remedial action
No button actuations are possible.
When the mains voltage reaches the
stipulated value again, the warning
message goes out. If the warning
message lasts for longer, inform the
energy supply company.