DeWalt DC351 Instruction Manual page 14

Cutting Depth Adjustment (Fig. 3)
The cutting depth can be set at 0–2-5/16" (0–59 mm) without track
attached; with the track attached: 0–2-1/8" (0–55 mm).
1. Loosen the depth adjustment knob (F) and move the pointer to
obtain the correct depth of cut.
2. Tighten the depth adjustment knob (F).
NOTE: For optimal results, allow the saw blade to protrude from the
workpiece by about 1/8" (3 mm).
FIG. 3
F
OPERATION
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. An
accidental start-up can cause injury.
Inserting and Removing the Battery
Pack (Fig. 4)
NOTE: Make sure your battery pack is fully charged.
1. To fit the battery pack (Z), line it up with the receptacle on the
tool. Slide the battery pack into the receptacle and push until the
battery snaps into place.
2. To remove the battery pack, push the battery release button
(AA) while at the same time pulling the battery pack out of the
receptacle.
FIG. 4
I
Z
U
Switching On and Off (Fig. 1)
Pull the on/off switch (B) to turn the motor on. Releasing the trigger
turns the motor off. This tool has no provision to lock the switch
in the "ON" position, and should never be locked on by any other
means.
Changing the Saw Blade (Fig. 1, 2, 5)
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. An
accidental start-up can cause injury.
12
AA