Key Pad Features - Danby DVAC10038E Use And Care Manual

DVAC8036 FINAL OM-.qxp 2006.02.23

Key Pad Features

Fresh Air Energy
Vent Saver
LED DISPLAY: Displays the following information
independently; Set Temperature, Ambient Room
Temperature and Auto Timer On/Off settings.
POWER: Turns unit On / Off.
MODE: Allows you to scroll through and select the
desired operating mode; Cool
Only and *Auto
be denoted by the adjacent indicator light. *'Auto' is
a pre-set factory program that automatically defines
the mode (Cool or Dry) and fan speed based on the
set temperature.
CHECK FILTER : The adjacent indicator light will
illuminate as a reminder to clean the air conditioner
filter (see page 9) Once the filter has been cleaned
and replaced, depress the Check Filter button in
order to resume operation.
SLEEP MODE : When activated, the current set
temperature is gradually increased over a one (1)
hour period then maintained for seven (7) hours.
Once the program is complete, the air conditioner
will resume to it's previous set temperature (before
sleep mode was activated). This feature is meant to
be used during the night time hours to prevent the
room from getting too cold (while you sleep) and
results in less compressor running time and
reduced energy consumption. Sleep mode may be
cancelled by depressing the Sleep Mode button
while the program is running.
FRESH AIR VENT: Remains in Closed
for maximum cooling or Open
air circulation during fan only operation.
ENERGY SAVER: Automatically cycles the fan on
and off while the compressor is not in use.
17:08 Page 11
Auto
Timer
Auto
LED Display
Mode
Selector
, Dry
. The selected mode will
Auto
to allow for fresh
Sleep
Mode
Temp/Timer
Control
FAN SPEED: Select from four different fan settings;
Low , Medium
and Fan Only mode.
mode the fan speed is automatically defined .
TEMP. /TIMER Control: Used to increase
decrease
increments.and Auto-Timer On/Off settings in 30
, Fan
min./1hr. increments. Note : To change the temperature
scale displayed on the control panel, press both
simultaneously to alternate the displayed
temperature between Celsius and Fahrenheit.
AUTO-TIMER:
Auto Off timer.
While the Air Conditioner is off (Auto-On):
1. Press the Auto-Timer button once and the
adjacent Auto-On indicator light '
2. Use the Temp/Timer control cursors
select a delayed On time of up to 24 hours.
3. Select the appropriate mode under which you
want the unit to operate (Auto-Cool-Dry-Fan Only)
4. Select the fan speed setting.
5. The time you selected will appear in the LED
display..
While the Air Conditioner is on (Auto-Off);
1. Press the Auto-Timer button twice and the
adjacent Auto-Off indicator light
2. Use the Temp/Timer control cursors
select a delayed Off time of up to 24 hours.
3. The time you selected will appear in the LED
display
position
The Auto On and Auto Off timer can operate during
the same program by defining the Auto-Off
parameters immediately after the Auto On
parameters.
The Auto-Timer may be cancelled at any time by
using the Temp/Timer control cursors
adjusting the timer length to 0.0.
5
Check
Power
Filter
Button
I/O
Auto
, High and Auto during Cool
Please note: During 'Dry'
the Temperature setting in 1°C / °F
Used to Initiate the Auto On and/or
will illuminate.
will illuminate.
Fan
Speed
or
to
to
and