Operating Instructions; Key Pad Features - Danby DAC10011E Owner's Use And Care Manual

Operating Instructions

KEY PAD FEATURES

Temp / Timer
Control
68
Check
Filter
Auto
MODE
Mode
Selector
Energy
Saver
LED DISPLAY: Displays the following information independently;Set
Temperature, Ambient RoomTemperature and Auto Timer On/Off settings.
POWER: Turns unit On/Off.
MODE: Allows you to scroll through and select the desired operating
mode; Cool , Dry , Fan Only and *Auto .The selected mode will be denot-
ed by the adjacent indicator light.*'Auto'is a pre-set factory program that
automatically defines the mode (Cool or Dry) and fan speed based on the
set temperature.
High and Auto during Cool and Fan Only mode. Please note: During 'Dry'
mode the fan speed is automatically defined .
compressor is not in use.
the Temperature setting in 1°C / °F increments, and Auto-Timer On/Off set-
tings in 30min./1hr. increments. Note: This appliance allows you select the
temperature scale to be displayed in either "Celsius" or Fahrenheit"
according to your preference.To change the temperature scale displayed
on the electronic display, press both the "Temp/Timer"adjust arrows simul-
taneously to alternate between "Celsius" & "Fahrenheit".
reminder to clean the air conditioner filter (see page 9) Once the filter has
been cleaned and replaced, depress the Check Filter button in order to
resume operation.
ally increased over a one (1) hour period then maintained for seven (7)
hours. Once the program is complete, the air conditioner will resume to its
previous set temperature (before sleep mode was activated). This feature
LED
is mean to be used during the night time hours to prevent the room from
Display
getting too cold (while you sleep) and results in less compressor running
time and reduced energy consumption. Sleep mode may be cancelled by
depressing the Sleep Mode button while the program is running.
AUTO-TIMER: Used to initiate the Auto On/ Auto Off timer.
Auto
Timer
While the Air Conditioner is off (Auto-On):
1) Press the Auto-Timer button once and the adjacent Auto-On indicator
Sleep
light will illuminate.
Mode
2) Use the Temp/Timer control cursors to select a delayed On time of
up to 24 hours.
3) Select the appropriate mode under which you want the unit to operate
Auto
(Auto-Cool-Dry-Fan Only)
4) Select the fan speed setting.
5) The time you selected will appear in the LED display.
While the Air Conditioner is on (Auto-Off):
Fan
Speed
1) Press the Auto-Timer button twice and the adjacent Auto-Off indicator
light will illuminate.
2) Use the Temp/Timer control cursors to select a delayed Off time of up
to 24 hours.
Power
Button
3) The time you selected will appear in the LED display. The Auto On and
Auto Off timer can operate during the same program by defining the
Auto-Off parameters immediately after the Auto On parameters.The
Auto-Timer may be cancelled at any time by turning the unit On/Off.
FAN SPEED: Select from four different fan settings;Low , Medium ,
ENERGY SAVER: Automatically cycles the fan on and off while the
TEMP / TIMER CONTROL: Used to increase or decrease
CHECK FILTER: The adjacent indicator light will illuminate as a
SLEEP MODE: When activated, the current set temperature is gradu-
8