Danby DVAC10038E Use And Care Manual page 4

DVAC8036 FINAL OM-.qxp 2006.02.23
Electrical Specifications
1. All wiring must comply with local and national
electrical codes and must be installed by a
qualified electrician. If you have any questions
regarding the following instructions, contact a
qualified electrician.
2. Check available power supply and resolve any
wiring problems BEFORE installing and
operating this unit.
3. This 115V air conditioner uses 11or less
nameplate amps and may be used in any
properly wired, general purpose household
receptacle. See Table 1 for specifications for
individual branch circuit.
4. For your safety and protection, this unit is
grounded through the power cord plug when
plugged into a matching wall outlet. If
you are not sure whether your wall outlet is
properly grounded, please consult a
qualified electrician.
5. The wall outlet (3-pin) must match the plug (3-
pin) on the service cord supplied with the unit.
DO NOT use plug adapters. See Table 2 for
receptacle and fuse information. If it is necessary
to use an extension cord to connect your air
conditioner, use an approved "air conditioner"
extension cord only. (available at most local
hardware stores)
6. The rating plate on the unit contains electrical
and other technical data.
Table 1: Suggested Individual Branch Circuit
Nameplate Amps
9.2 to11
AWG- American Wire Gage
* Based on copper wire at 60 °C temperature rating.
Receptacle and Fuse Types
Table 2:
Rated Volts
Amps
Wall Outlet
Fuse Size
Time Delay Fuse
(or circuit breaker)
17:08 Page 7
AWG Wire Size*
14
125
15
15
Plug Type
3