Life Fitness Platinum Club Series Assembly Instructions Manual
Life fitness platinum club series treadmills
Hide thumbs
Also See for Platinum Club Series:
- Assembly instructions manual (49 pages) ,
- Operation manual (44 pages) ,
- Operation manual (15 pages)
Advertisement
Advertisement
Table of Contents
Related Manuals for Life Fitness Platinum Club Series
Summary of Contents for Life Fitness Platinum Club Series
- Page 1 Platinum Club Series Treadmills Assembly Instructions...
-
Page 2: Important Safety Instructions
DO verify the contents of the delivery carton against the accompanying parts listing prior to set- ting the cartons and shipping material aside. If any parts are missing, contact Life Fitness Customer Support Services at the number listed on the back page of this assembly instruction booklet. -
Page 3: Tools Required For Assembly
TOOLS REQUIRED FOR ASSEMBLY... #2 Phillips screwdriver, 4mm Allen Head Driver (T-Bar recommended), 8mm Allen Head Driver PARTS DESCRIPTION UPRIGHT Qty: 1 M12 x 1.75 HEX BUTTON HEAD SCREW Qty: 16 0017-00101-1984 M12.5 WASHER Qty: 16 UPRIGHT Qty: 1 0017-00104-0489 CONSOLE BRIDGE Qty: 1 CONSOLE BRACKET... - Page 4 IMPORTANT DO NOT DISCARD THE SHIP KIT LOCATED ON TOP OF THE DECK AND BELT. ALL NECESSARY COMPONENTS NEEDED TO COMPLETE THE INSTALLATION ARE LOCATED IN THE SHIP KIT. NE JETEZ PAS LE KIT D'EXPÉDITION PLACÉ SUR LE DESSUS DU PLATEAU ET SUR LE TAPIS. IL CONTIENT TOUS LES ÉLÉMENTS NÉCESSAIRES POUR L'INSTALLATION.
- Page 5 Locate the LEFT HANDRAIL (9). With the plastic trim facing upward, slide the LEFT HANDRAIL into the LEFT HANDRAIL BRACKET (J) located on the CONSOLE BRIDGE (5). Secure the LEFT HANDRAIL using two BOLTS (2) and WASHERS (3) from the side as shown. Leave the BOLTS loose at this time.
- Page 6 Locate the BOTTOM COVER (21). Remove the ACCESS DOOR (N) and set it aside. Drop the POLAR CABLE (O) through the opening. Install the BOTTOM COVER to the CONSOLE BRIDGE (5) using twelve SCREWS (7). Connect the POLAR CABLE to the connector located under the CONSOLE BRIDGE.
- Page 7 Remove the protective backing from the four HOOK AND LOOP FASTENERS (S) located on the back of the LEFT SIDE EXTRUSION (31). Align the LEFT SIDE EXTRUSION with the channel in the LEFT SIDERAIL (T) and REAR ENDCAP (29) as shown. Tilt and engage the LEFT SIDE EXTRUSION to the LEFT SIDERAIL. Press firmly on the underside of the LEFT SIDE EXTRUSION to secure the HOOK AND LOOP FASTENERS to the frame.
-
Page 8: Dimensions
Before attempting to operate your Treadmill, it is imperative that you familiarize yourself with the contents of the Operation Manual. If your Life Fitness treadmill does not respond as described in the OPERATION MANUAL contact the nearest Life Fitness Service Center as listed in the OPERATION MANUAL.