Compact Disc Operation; Play/Pause Mode - Hyundai H-1434 Instruction Manual

Instruction manual
an appropriate position for the best reception.
FM/FM stereo reception
• In particular when stereo signal is weak
and much noise are received, it is preferable
to receive programs in mono mode. Set the
band switch to FM ST position to receive radio
programs in stereo mode.
• If the program is received in FM stereo,
"ST" indicator will light up.
Disc operations
Insertion and removal of discs
• Pull up the CD compartment door. Place
a disc into the compartment with the label-side
(printed side of disc) facing upwards. Press
down in the center part of disc until the disc
locks onto the center spindle.
• When the disc has been placed onto
the center spindle, gently lower the CD-door
downwards until it locks shut. The disc is now
ready to be played.
• When opening the CD-door, always
ensure the disc is not in motion (not spinning)
when you open the CD-door. Always press
STOP button to stop the disc spinning first.
• To remove the disc, follow the same
procedure as described above, except to
remove the disc instead of inserting it into the
compartment, by placing one finger at the
middle of disc (center spindle) and the other at
the edge of the disc and gently pulling upwards.
Always hold a disc by its edges. Avoid
getting any fingerprints, smudges or dirt onto
the surface of a disc. In case this happens, use
a special CD-cleaning cloth or cleaning kit to
remove the dirt or smudges.
Important: Please make sure to always fold
down the handle before opening the CD door.

Compact disc operation

• Set function switch to CD position.
• Put a disc into the CD compartment and
close the CD door.
4
• The display will show the total number of
tracks after a few seconds.
• If there is no disc in the unit, the display
will show "NO". If the CD compartment door is
not closed properly, the display shows "---".

Play/pause mode

• Press PLAY/PAUSE button to start
playback, the display will show the current
track number and playback symbol.
• Press PLAY/PAUSE button to pause at
any track when playing, playback symbol on
the display flashes. Press this button again to
resume playback.
• To stop playback, press STOP button. The
display will show the total number of tracks on
the disc.
Skip and search mode
• Press SKIP/SEARCH button once
to skip to the next track. Press and hold this
button to search for a particular point at high
speed forward. Release the button to resume
normal playback.
• Press SKIP/SEARCH button once
to skip to the beginning of the current track.
Press SKIP/SEARCH button twice to skip
back to previous track. Press and hold this
button to search for a particular point at high
speed backward. Release the button to resume
normal playback.
• If you use an MP3 disc containing folders,
you can select a folder. In stop mode, press
repeatedly FOLDER button. The number of
the current folder will be displayed. After you
selected a folder you can select tracks in the
current folder as described above.
Repeat mode
• Press MODE button once for single track
repeat playing. REP will be displayed.
• If you use an MP3 disc containing folders,
press this button again to repeat all tracks in
the current folder. The track number and folder
number will be shown every few seconds
alternatively.
• Press MODE button again for all track