Program Mode; Usb/Sd/Mmc-Card Playback - Hyundai H-1434 Instruction Manual

repeat playing.
• Press MODE button again for all track
random playing. RANDOM will be displayed.
• To cancel repeat or random playback,
press MODE button again.

Program mode

Up to 20 tracks can be programmed for disc
play in any order or the same track can be
repeated up to 20 times.
• Before use, be sure to stop the CD by
pressing STOP button.
• Press PROGRAM button. The display will
show "P01" and "PROGRAM". This indicates
that the set is now in memory programming
mode, at the first memory position.
• If you use an MP3 disc, press FOLDER
button to select a folder.
• Select a desired track by using
SEARCH and SKIP/SEARCH buttons.
• Press PROGRAM button again to confirm.
The set will advance to next memory position,
the display will show "P02". Repeat two steps
described above to enter additional memories
into the program if necessary.
• After the maximum of 20 songs (or less)
have been selected as described above,
press PLAY/PAUSE button to start playing the
programmed tracks.
• The "PROGRAM" symbol will remain on
to indicate that you have saved a program-
memory (sequence).
• To check the program you stored, after
the programming is completed, in stop mode
press PROGRAM button (for MP3 discs - after
PROGRAM button press FOLDER button
to see the folder number), then press
SKIP/SEARCH button repeatedly to see all
programmed track numbers.
• The program memory will be cleared when
you press STOP button twice, open the disc
compartment door or turn off the disc player or
power supply.
Good quality sound is guaranteed only
when playing licensed MP3 discs.
Instruction manual

USB/SD/MMC-card playback

• This unit is equipped with a USB socket
that can accept and play MP3 files stored on
standard USB flash (compatible with USB
version 2.0) up to 8 Gb.
• This unit is also equipped with an SD/
MMC card socket that can accept and play
MP3 files stored on standard SD cards up to
32 Gb.
• To use USB drives/SD/MMC cards for
MP3 playback, slide the function switch to CD
position. Insert the USB drive or SD/MMC card
into the appropriate socket and repeatedly
press CD/SD/USB button until the display
shows "USB" or "CARD" (depending on which
one is being used).
• All operations with files contained in USB/
SD/MMC are the same as operations with MP3
discs.
SKIP/
Always switch off the unit or change
mode to CD before removing a USB flash drive
or SD/MMC card, to prevent damage to your
USB device or memory card.
Note: Although this product is fully
compatible with USB 2.0 and SD/MMC card
standard formats, a small percentage of USB
flash drives and SD/MMC cards might not be
readable, due to those device manufacturers
non-compliance with the full (official) USB and
SD cards standards.
"Dynamic Bass Boost" system
For increased bass at all volume levels,
press BASS BOOST button for an emphasized
bass sound. Press the button again to disable
the function.
Maintenance and care
• Check your batteries regularly, old or
discharged batteries should be replaced. If the
unit is not going to be used for some time or is
being run exclusively on the alternative power,
5