Selecting Stored Stations; Compact Disc Operation; Play/Pause Mode - Hyundai H-1416 Instruction Manual

Portable stereo radio cassette recorder with cd/mp3/usb/sd/mmc
Hide thumbs Also See for H-1416:
Table of Contents

Advertisement

Available languages

Available languages

Instruction manual
when a broadcast station is received.
• To receive a weak broadcast signal press
the NEXT/TUNE-UP or BACK/TUNE-DOWN
button by one press at a time and adjust the
frequency you wish to receive.
Saving Stations to Memory
• 50 broadcast stations: 30 FM band and 20
AM stations can be stored to the preset memory.
• During tuner mode, find a desired station.
• Press SKIP +10/FOLDER/MEM.SET
button to activate memory setting mode. The
"MEM" symbol will appear on the display.
• Press NEXT/TUNE-UP button or BACK/
TUNE-DOWN button to choose the desired
memory location. The location number is
flashing on the left side of the screen.
• Press SKIP +10/FOLDER/MEM.SET
button again to store the desired station.
• Repeat steps for storing stations to other
locations.
• To clear the memory of any location simply
save a new station to the same memory.

Selecting stored stations

• Press REPEAT/PROGRAM/MEMORY
button on the unit or PLAY MODE/MEMORY
button on the RC once. "MEM" symbol will
appear on the display.
• Press NEXT/TUNE-UP or BACK/TUNE-
DOWN button to choose the memory location.
The stored station will be selected.
Antenna
• For FM reception, adjust the telescopic
antenna appropriately to obtain the best
reception on the band selected.
• The AM signals are picked up through
the built-in ferrite antenna. The set should be
placed to a position for the best reception.
FM/FM stereo reception
• In particular when stereo signal is weak
and much noise are received, it is preferable to
receive the programmer in mono. Press STOP/
CD/USB/SD/FM MODE button on the unit or
STOP/FM MODE on the RC to switch between
4
FM stereo and mono modes.
• If the program is received in FM stereo,
"ST" indicator will light up.
CD operations
Insertion and removal of discs
• Place a CD into the compartment with the
label-side (printed side of disc) facing upwards.
Press down in the center part of disc until the
disc locks onto the center spindle.
• When the CD has been placed onto the
center spindle, gently lower the CD-door
downwards until it locks shut.
• The CD is now ready to be played.
• When opening the CD-door, always
ensure the disc is not in motion (not spinning)
when you open the CD-door. Always press
STOP/CD/USB/FM MODE button on the unit or
STOP/FM MODE button on the RC to stop the
disc spinning first.
• To remove a disc, follow the same
procedure as described above, except to
remove the CD instead of inserting it into the
compartment, by placing one finger at the
middle of disc (center spindle) and the other at
the edge of the disc and gently pulling upwards.
Always hold a CD by its edges. Avoid
getting any fingerprints, smudges or dirt onto
the surface of a disc. In case this happens, use
a special CD-cleaning cloth or cleaning kit to
remove the dirt or smudges.
Important: Please make sure to always fold
down the handle before opening the CD door.

Compact disc operation

• Set FUNCTION switch to USB/SD/CD
position.
• Put a CD into the CD compartment and
close the CD door.
• The LCD display will show the total
number of tracks after a few second.

Play/pause mode

• Press PLAY/PAUSE/BAND (AM/FM)
button on the unit or BAND/PLAY/PAUSE

Advertisement

Table of Contents
loading

Table of Contents