Sound Adjustment; Radio Operation - Hyundai H-2203 Instruction Manual

FUNCTION
FUNCTION SWITCH
· Position to RADIO for:
-Radio reception
-Cassette recording from the radio
· Position to TAPE for:
-Cassette playback
-Recording from built-in Condenser Microphone

SOUND ADJUSTMENT

VOLUME
The level of sound reproduced by the loudspeaker or Stereo Headphones is adjusted by the VOLUME control.
NOTE:
During recording, adjusting the VOLUME control only affects the monitor sound and not the content of recording.

RADIO OPERATION

OPERATION
· Set Function switch to RADIO position thus the Power LED indicator should light up.
· Select your desired broadcasting band with Band switch.
· Rotate the Tuning control regulator to receive the desired broadcast.
· Adjust the level and quality of sound with Volume control switch.
· To turn off the radio, set the Function switch to TAPE position.
ANTENNA
· For FM reception, adjust the telescopic antenna appropriately to obtain the best reception on the band selected.
· The AM signals are picked up through the built-in ferrite antenna. The set should be placed to a position for the best reception.
FM AND FM STEREO RECEPTION
· Set Band switch FM position, programmer is received in mono mode.
NOTE: In particular when stereo signal is weak and much noise are received, it is preferable to receive the programmer in mono.
· Set FM MODE switch to FM STEREO position, programmer is received in stereo mode, thus FM STEREO LED should light up.
4