Table of Contents
Advertisement
stored and can be read using the programmer (see next
section). To return to normal operation, cycle power
without the PTT switch pressed or press FCN RCL.*
2.14.2 READING ERROR CODES
The up to 11 error codes that can be stored can be
read out of the transceiver using the personality
programming software described in Section 3.7.
Connect the programming setup and then select
Figure 2-4 Programmer Error Code Screen
2-32
Transfer > Read * Codes or click the
toolbar (see Section 3.7).
The screen shown in Figure 2-4 is then displayed
which indicates various information about each stored
error code. Contact the Customer Service Department
as described in Section 1.7 for additional information
on the displayed error codes. To permanently erase the
current error codes from the transceiver, click the
"Clear
Codes" button at the bottom of the screen.
*
OPERATION
icon in the
November 2001
Part No. 001-7240-001
Advertisement
Table of Contents
