Page 1
MODEL T250S-F16 16 Gauge Straight Finish Nailer IMPORTANT! OPERATING MANUAL AND DO NOT DESTROY TOOL SCHEMATIC It is the customer’s responsibility to have all operators and service personnel read and understand this manual.
Page 2
INTRODUCTION The PASLODE T250S-F16 finish nailer is a quality-built tool designed for use in residential ® trim applications. This tool will deliver efficient, dependable performance when used according to the manufactures guidelines. Please study this manual including the safety instructions to fully understand the operation of this tool.
WARNING Failure to follow any of the above instructions could result in severe personal injury to tool user and bystanders or cause damage to tool and property. Contact your local Paslode Representative for presentation of Paslode’s Safety Awareness Program...
Loading Fasteners STEP 1: Align the heads of the Paslode 16 ga.Finish nails to the brad channel in the rear of the magazine and insert one or two strips. Push the nails strips forward.
Page 6
TOOL OPERATION Trigger Methods: The Paslode T250S-F16 Finish Nailer has a triggering system than can be switched from sequential to contact trip. To switch the trigger, press in the round orange button on the right side of the trigger and rotate the left side of the button to the desired triggering method.
❑ Reduce the regulated air pressure to 30 psi. ❑ Use only Paslode approved fasteners in the tool, and ensure that they are correct for the application. ❑ Remove all fasteners from the tool. ❑...
Page 8
Keep lubricator filled. Keep tool lubricated. Fill with Paslode pneumatic tool lubricant. Part No. 219026. Clean filter element, then blow Prevent clogging of filter with Wash with soap and water or air through filter in direction dirt.
Clean as needed to from time to time. remove debris. Make sure correct fasteners are being used. Use fasteners that meet Paslode ® specifications only. Increase air flow to tool -- use larger air lines (3/8 ID minimum).
Page 10
PARTS LEGEND T250S-F16, 501680 501092 Dust Cover 501885 T.H.S.C.S. 1/4-20 x 1/2 501972 Bolt 501896 Flat Washer 501091 Air Plug 501899 Deflector 501939 Belt Hook 501901 Bolt 501938 Hex S.H.C.S. 501902 501998 Spring Pin 501903 Seal 501931 Spring Pin 501904...
Page 11
T250S-F16 501680 Driver Blade Assembly #501987 Trigger Valve Assembly #501988 Assembly Hardware System - Metric WARNING All parts must be periodically inspected and replaced if worn or broken. Failure to do this can affect the tool’s operation and present a safety...