Advertisement
1
Orient the release key
correctly.
1
2
1 8 2
m m
5 3 m
m
Claws
Precautions
Mounting the unit in a Japanese
car
• Choose the installation location carefully so that the
unit will not interfere with normal driving operations.
You may not be able to install this unit in some makes of
• Avoid installing the unit in areas subject to dust, dirt,
Japanese cars. In such a case, consult your Sony dealer.
excessive vibration, or high temperatures, such as in
Note
direct sunlight or near heater ducts.
To prevent malfunction, install only with the supplied screws .
• Use only the supplied mounting hardware for a safe
and secure installation.
How to detach and attach the
Mounting angle adjustment
front panel
Adjust the mounting angle to less than 45°.
Before installing the unit, detach the front panel.
Removing the protection collar
and the bracket
-A To detach
Before detaching the front panel, be sure to press .
Press
, and pull it off towards you.
Before installing the unit, remove the protection
collar and the bracket from the unit.
-B To attach
1
Remove the protection collar .
Engage the release keys together with the
Engage part of the front panel with part of the unit,
protection collar
.
as illustrated, and push the left side into position until it
Pull out the release keys to remove the
clicks.
protection collar
.
2
Remove the bracket .
Insert both release keys together between
Warning if your car's ignition
the unit and the bracket
until they click.
has no ACC position
Pull down the bracket
, then pull up the unit
to separate.
After turning the ignition off, be sure to press
and hold on the unit until the display
Frequency select switch
disappears.
Otherwise, the display does not turn off and this causes
The AM (FM) tuning interval is factory-set to the 9 k
battery drain.
(50 k) position. If the frequency allocation system of
your country is based on 10 kHz (200 kHz) interval, set
RESET button
the switch on the bottom of the unit to the 10 k (200 k)
position before making connections.
When the installation and connections are completed, be
sure to press the RESET button with a ballpoint pen, etc.,
after detaching the front panel.
Mounting example
Installation in the dashboard
Notes
• Bend these claws outward for a tight fi t, if necessary (-2).
• Make sure that the 4 catches on the protection collar are
properly engaged in the slots of the unit (-3).
2
Face the hook inwards.
3
Dashboard
A
TOYOTA
max. size
5 × 8 mm
Bracket
Existing parts supplied with your car
Fire wall
A
Connecting the parking cord /
Using the tap 8 /
Parking brake switch cord
8
Parking cord (light green)
Note
If the parking brake switch cord is too thin, connect the parking cord to the parking brake switch cord
directly without using the tap.
Battery power
Parking brake warning light
Parking brake switch cord
Foot brake type
Parking brake switch cord
B
NISSAN
max. size
5 × 8 mm
to dashboard/centre console
max. size
5 × 8 mm
Bracket
B
c
CDX-V2800
Parking cord (light green)
8
Parking brake switch
Body earth
Hand brake type
Parking brake switch cord
to dashboard/centre console
Bracket
max. size
5 × 8 mm
Bracket
Existing parts supplied with your car
Advertisement
