Meat Probe And Outlet - GE PT920 Technical Service Manual

Meat Probe and Outlet

If equipped, the meat probe outlet is located on
the top of the oven cavity, near the front. The meat
probe outlet is connected to the electronic oven
control. The meat probe has a resistance value of
30K-50K Ω at room temperature.
To remove the meat probe outlet:
1. Open the oven door.
2. Remove the two -in. hex-head screws that
/ 1
4
hold the meat probe outlet to the top of the oven
cavity.
3. Remove the control panel (see
Compartment Access
probe connector.
4. Pull the probe outlet wiring through the meat
probe outlet.
Meat Probe Outlet
Note: Upon reassembly, ensure displaced insulation
around oven and components is returned to its
original position.
Control
) and disconnect the meat
Bake Element
Note: The resistance of this component can be
tested from the EOC. (See
The element is rated at 2100 watts, has an
approximate resistance value of 27 Ω, and draws
approximately 8.5 amps.
The bake element is located under the oven fl oor.
Bake element terminals are located behind the rear
access panels on both the single and double wall
ovens.
To remove a bake element:
1. Remove the oven from the installation. (See
.)
Removal
2. Remove the left side access panel for the
appropriate bake element. (See
.)
Panels
3. Carefully lift the insulation from the outside of
the oven to access the screws that hold the
bake element cover in place.
4. Remove two ¼-in hex-head screws and the
bake element cover from oven.
Bake Element Cover
5. Remove 1/4-in. hex-head screws and bake
element terminal cover from oven.
6. Disconnect the wires from the bake element.
– 31 –
.)
Control Board Testing
Oven
Side Access
(Continued Next Page)