Lower Oven Control Compartment Access; Top Access Panels - GE PT920 Technical Service Manual

Lower Oven Control Compartment Access

Note: It may be necessary to remove the oven from
the installation to gain access to some components.
(See
Component Access Chart
To access the lower oven control compartment:
1. Remove the upper oven door. (See
.)
Assembly
2. Remove the 2 Phillips-head screws from the top
of the middle trim.
3. Open the lower oven door.
4. Remove the three 1/4-in. hex-head screws from
the bottom of the middle trim. Remove the trim.
Middle Trim
5. Remove the four 1/4-in. hex-head screws
that attach the cross member to the front
of the control compartment. Remove the
crossmember.
Screws
.)
Door
– 20 –
6. Remove the two 1/4-in. hex-head screws from
the relay board tray.
7. Remove the four 1/4-in. hex-head screws (one
under the relay board) that attach the vent trim
to the front of the cabinet. Remove the trim.

Top Access Panels

Removing the top access panels permits access to
the control compartment, cooling fan, and the bake
FAD thermal.
The oven must be removed to access the 1/4-in.
hex-head screws that attach the top panels. (See
.)
Oven Removal
The front top access panel has 5 hex-head screws.
The rear top access panel has 8 hex-head screws.