Retracting The Upper Cutter - Husqvarna HUSKYLOCK 1002 Handbook

2. Retracting the upper cutter
fU ION!
Set the overlock stitch width so that it is not wider than the scale on the stitch width control dial. If the overlock
stitch width is set too wide, the upper looper will pull the edge of the material, which will cause problems with
sewing.
Before starting sewing, close the material plate cover (front).
To cut the edges of two or more pieces of material and sew them
In this case, set the upper looper so that it will not
operate, and then start double chain stitch sewing with the cutter
still
iii
thc' operation condition.
It is riot necessary to replace the cutter
cover
with cutter cover II at this time.
To sew without cutting the material
1) Raise the needle above the needle plate.
2) Open the material plate cover (front), and then push and turn the cutter retracting knob to retract the upper cut
ter.
-
26
-