Set Button - Hyundai H-1625 Instruction Manual

Remote controller
1
2
3
4
1. button

2. SET button

3. MODE button
4. RADIO button
5. SNZ button (corresponds to SNOOZE
button on the unit)
6. ALM button (corresponds to ALARM button
on the unit)
7. VOL+/VOL- buttons
8. / buttons (correspond to
buttons on the unit)
Important safeguards
• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer the manual.
Keep the manual for use in future.
• Do not hit or drop the unit.
• Do not expose the unit to vibration, direct
sunlight, too high or low temperature or humidity.
• Do not disassemble the unit yourself.
Refer servicing to qualified service personnel.
• When the battery is exhausted, it should
be removed from the set to prevent leakage.
5
6
7
8
/
Instruction manual
Power supply
Battery power
• The built-in battery used for the unit power
supply is rechargeable. The battery must be
fully charged before the first use. The first
charging time should be about 14...16 hours.
It will reach its optimal performance after fully
charged and discharged for a few times.
• To ensure the battery in optimal state,
it is recommended to discharge the battery
fully once each month at least by using up the
power so as to switch off the unit.
• In course of charging, it is normal to find
the battery and the unit warm up slightly. The
unit can automatically self-protect so as to suit
for the temperature.
Actual time of usage for the battery
varies according to operation mode.
Procedure for battery charging
• Connect the adapter to a power supply
socket, and insert the charging plug into the
Power input of the unit.
• The unit will start charging after well
connected. The power indicator will light up in
red.
• When fully charged, the course of charging
stops automatically. Now the adaptor can be
unplugged from the unit.
To ensure safety, neither change the
parts and fitments of the battery by yourself nor
unwrap the battery. We suggest you use only
the battery and the adapter supplied with the
unit, so as not to do the damage to the unit.
Additional power
There are 2 batteries AG13 (1.5 V) in the
terminal inside the battery compartment. This
is additional power intended for operation
of clock, alarm, calendar, termometer and
countdown timer. Without the additional power
the time and alarm settings will not be stored if
the unit is switched off.
3