Shoulder Strap Adjustment - Weed Eater BV200 Instruction Manual

5. Place the hooks of the upper vacuum tube
on the retaining posts of the unit.
6. Pivot the tube until it is secured to the
blower unit by the vacuum inlet latch.
PIVOT
Inlet Cover
Latch
Hook
HOW TO CONVERT UNIT FROM
VACUUM USE TO BLOWER USE
1. Remove the vacuum tubes by inserting
the tip of a screwdriver into the latch area
of the vacuum inlet.
2. Gently tilt handle of screwdriver toward
the back of the unit to release the latch
while pulling up on the upper vacuum tube
with your other hand.
Latch Area
3. Remove the vacuum bag.
4. Close the vacuum inlet cover and make
5. Reinstall the blower tube (see BLOWER

SHOULDER STRAP ADJUSTMENT

1 Hold the unit as shown with the muffler side
2. Pass the shoulder strap over your head
3. Extend your left arm toward the rear of the
4. Adjust shoulder strap until the vacuum
5. Make sure air flows freely from the elbow
Retaining
Post
-- 6 --
sure it is latched closed.
TUBE ASSEMBLY).
facing away from your body and clothes.
and onto your right shoulder.
vacuum bag.
bag/shoulder strap seam lies between
your thumb and index finger.
tube into bag. If bag is kinked, the unit will
not operate properly.