Master/Slave Mode; Dmx Mode - Luxibel LX103 User Manual

Custom Static Colours
This device allows you to create custom static colours.
1. Press <MENU> until
2. Press <ENTER> to confirm your selection.
3. Use <UP> or <DOWN> to select the desired colour.
4. Press enter to change the red colour value (
5. Press <ENTER> to confirm and to move to the next colour (green, blue). Set the value for the
second and third colour.
7.4

Master/Slave Mode

This mode allows control several units simultaneously.
1.
Use standard DMX cables to daisy-chain your units together via the DMX connector on the rear of
each fixture. For longer cable runs we suggest using a terminator on the last fixture.
2.
Choose the first unit in the chain to function as the master fixture. Press <MENU> and choose a
,
mode (
3.
On each of the connected slave units, set the same channel mode as the master (via
Chasing Mode
This mode allows multiple units to run in sequence.
1.
Press <MENU> until
2. Press <ENTER> to confirm your selection.
3.
Use <UP> or <DOWN> to select
4. Press <ENTER> to confirm your selection.
5.
Use <UP> or <DOWN> to select the position of the device in the chase:
On the master, set the position to
o
On the slaves, set the position to
o
chain.
Note: for older devices revision 1.0, set the master to address
~ .
7.5

DMX Mode

This mode allows you to control the fixture by any universal DMX controller.
•
All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to "listen" to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.
•
When all devices have the same address, all the units will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will "listen" to a separate channel
number. Changing the settings of one channel will only affect the device in question.
Example:
In case of the 9-channel LX103, you will have to set the start address of the first unit to 1
o
(CH1~9), the second unit to 10 (1 + 9) (CH10~18), the third to 19 (10 + 9) (CH19~27), and
so on.
1. Press <MENU> until the desired DMX channel mode (
, or
2.
Press <ENTER> to confirm your selection.
3.
Use <UP> or <DOWN> to select the desired DMX starting address (
DMX Channel Values
3-Channel Mode
channel function
1 red
2 green
3 blue
V. 04 – 11/12/2013
is displayed.
or ).
is displayed.
or
) is displayed.
from
000
000
000
LX103
~ , from 0 to 100%).
.
~ depending on the physical layout of the
,
to description
255 dimmer 0 ~ 100%
255 dimmer 0 ~ 100%
255 dimmer 0 ~ 100%
7
; set version 2.0 slaves to
, , ,
~ ).
©Velleman nv
).
,