Burn-In Pattern - Dell ST2010 Service Manual

Service Manual
y Mode Introduction
Factor
With signal input, press "Power" button on right corner of front bezel
monitor. Press first and second buttons on OSD key (from up to down) together, and
then press "Power" button to turn on the monitor. After power on, the device is enter
factory modode ,press " buttons to call out factory menu (see the following Fig)
[Ù]"
Exit: Exit from Factory mode and back to NO OSD Status.
Panel: The current-setting panel is highlighted.
Auto Color: Automatically calibrate chip ADC parameters by using internal DAC.
Burn In: Enable or disable the Burn-in mode by choosing ON or OFF.
Reset Time: Reset the "Turn-on time" of the panel to 0H0M.
Color Temp: The R, G, B of Blue Preset (9300K), Red Preset (5700K) and Normal
Preset (6500K) are generated
from scaling chip's back-end white-balance program.
Time: Turn-on time of the panel.
DEBUG: Debug tool of scale IC U105.
Dell panel P/N
PANEL Supplier P/N
SAM LTM200KT03

5.4 Burn-in pattern

Burn-in pattern will self-generate automatically without VGA and HDMI cable plugged
in when the monitor set at Burn-in on mode and burn-in pattern will not be stopped until
plugging in the VGA /HDMIcable. Exit Burn-in mode method as followe: plugging in
the VGA/HDMI cable, press "Menu" button to call out OSD Main Menu, Press "Plus
Key"to select"Other Settings submenu"then choose Factory reset.
35
to turn off the
CODE PANEL
F747N SAM