Minelab F3 Operation Manual page 27

a. Disabling and Enabling LED Display. The F3L factory pre-set
is LED display enabled but this feature can be disabled or
enabled as follows:
• • • •
Disable. With the detector switched on, to disable the LED
display, press and hold the
press and release the green Ground Balance button.
Once the LED display is disabled, unless subsequently enabled, the
LEDs will remain extinguished even if the detector is repeatedly
switched off and on.
•
Enable. With the detector switched ON, to enable the LED
display, press and hold the
press and release the green Ground Balance button.
Once the LED display is enabled, unless subsequently disabled, the
LEDs will be illuminated whenever the detector is switched on.
If an Earset Speaker OFF is connected to the detector, the LED
display will be automatically disabled for tactical reasons. However,
if required the LED display can be enabled as described above.
button and simultaneously, quickly
NOTE
button and simultaneously, quickly
NOTE
26