BMW 525i Owner's Manual page 70

Calling up stored reports on Control
Display
Using the CHECK button
1. Press the button longer:
The first stored message is displayed
2. Briefly press the button:
Another message is displayed each
time the button is briefly pressed.
Using the Control Center
Control Center, for principle details, refer to
page 16:
1. Press button.
The start menu is opened
2. Press the controller to open the
3. Select "Service" and press the control-
ler
4. Select "Check Control messages" and
press the controller. The stored mes-
sages appear on the display
5. Select the desired message and press
the controller.
68
The display disappears automatically after
a short time.
To close the display immediately:
Select
Displays after completion of trip
Malfunction reports generated during the
trip are shown consecutively when you
switch off the ignition.
Before the display disappears, you can dis-
play the messages once again. Press the
CHECK button for approx. 2 seconds. If
several messages are present, you can
continue to press the CHECK button to
view them in succession.
The display goes out
>
>
Computer
menu
Requesting functions
As of ignition key position 1, you can use
the BC button in the turn signal lever to call
up computer information in the instrument
cluster.
Online Edition for Part No. 01 41 0 158 159 - © 02/04 BMW AG
and press the controller.
automatically after a brief period
by again pressing the CHECK button
for approximately 2 seconds.